Tiger DMX DC Controllers
TigerDMX120LC DC Controller.
The TigerDMX120LC DC controller is designed for use with RGB LED Light strings.
The TigerDMX120LC DC controller can work from 12v to 36v DC and is powered by the same voltage
as the lights and can switch up to 100mA per channel.
Features
- 120 channels
- 12v DC to 36v DC
- DMX512A input - RJ45 Connector
- 100mA per channel MAX
- Output via 0.1 inch header pins
- 1Mb Onboard memory for hardware dimming curves (dimming curves not implemented in firmware yet)
- Onboard 5v Switched Mode Power
- Outputs arranged for RGB LED support
- Header for Wireless DMX Receiver outputing serial data
TigerDMX120LC Version 1
Progress updates can be found over on the support forum TigerDMX120 Board A short video can be found here, right at the start is the 120ch controller running 24 channels of RGB leds at the bottom of the frame, up top is last years 48ch board for comparison. It is hoped that production units will be available by the end of May, subject to successful testing This board will have some quite small surface mount components and will be supplied with all SMD reflow soldered onboard. This will leave the Christmas light fanatic to solder the input and output connectors and load firmware. Bare boards will be available for the brave and/or experienced.
Cost
Preliminary costing will be around US$100 as a kit with all components. Fully tested units will have limited availability (subject to time to build) and I hope these can be made available for US$125. Packing and Shipping Charges not includedPlease email me if you would like to know more